Rocket Garage Door Repair - garage door installation Ballwin

How to install a Garage door, initial steps

If you want to install the garage door on your own then you have followed these steps:

Step 1  

You will need to post the tension from the torsion spring before starting work on the door. It starts by locking the adjustable hinges onto the torsion spring shaft and then wedges the pliers from the headboard wall above the door. Add a steel pole into one of those holes on the lava cone of the spring, and this includes four holes used for tightening and firming. Hold firmly in the pole and loosen the set screws holding the torsion cone set. Use the steel sticks to loosen the spring a quarter flip at a time. Alternate the 2 sticks, using you to keep the cone stable and another to flip the cone after the first pole is cleared.

Step 2

Start at the very top and remove the hinges attached to the plate below. When using glass, work carefully. Separate the track by unscrewing or loosening it in the door frame. If you intend to swap out your auto door opener, then get rid of the opener's trace from over . Eliminate the old automated garage door opener.

Step 3 

Start with the panel at the top and remove the hinges attached to the plank below Disconnect the trail by unscrewing or unlocking it in the door frame If you intend to replace your automated door opener , eliminate the opener track from above and eliminate the opener.

Step 4

If you are installing a two car garage door, place a reinforcement bar on the top panel to prevent the door from tilting in the middle. Make sure the bar is resting on the panel. Make pilot holes and secure the pub with screws. . Twist hinges on the top of each panel Many new doors arrive with pilot holes drilled by the manufacturer Set the base panel to the door opening Hold the panel upright by hammering a nail into the wall near the plank fold it to hold the panel in position. Make sure it is flat before attaching another panel.

Install the garage door

After following the steps above, it is now time to install your garage door panels. So let it begin. When installing a mirrored garage door, place a reinforcement bar on the top plate to hold the door in the center from the inside. Make sure the rod is drill pilot holes and secure the pub with screws . rotary hinges at the top of each plate. Many new doors arrive with pilot holes drilled by the manufacturer. The pivot axis supports the base of the floor panel and also to the top of the tallest panel. Place the base panel on the door opening. Keep the board vertical by hammering a nail into the wall near the plank and then bending it to hold the board in place. Make sure it is flat before attaching another panel.