garage door repair - garage door repair st louis

How to install a Garage door, initial steps

If you want to install the garage door on your own then you have followed these steps:

Step 1  

You will need to post the tension from the torsion spring up before you start working on the door. one of those holes in the lava cone of the spring, and this includes four holes that are used for tightening and firming. Firmly hold the post and loosen the set screws that hold the rotating cone. Flip in a moment. Stagger the 2 sticks, using one to keep the cone stable and another to flip the cone after the first pole is removed.

Step 2 

Start at the top panel and remove the hinges attached to the bottom panel. When using glass, then work carefully. Disconnect the path by unscrewing or unscrewing it at the door frame. If you intend to replace your automatic garage door opener, then remove the opener trace from over. Remove the aging automated garage door opener.

Step 3

Start with the panel at the top and remove the hinges attached to the plank below Disconnect the trail by unscrewing or unlocking it in the door frame. and eliminate the opener.

Step 4

If you are installing a two-car garage door, attach a rebar to the top panel to prevent the door from sagging in the middle. Make sure the bar is based on the table. Drill pilot holes and fix the pub with screws. .40 to 4 Rotate the hinges at the top of each panel. Many new doors are arriving with pilot holes drilled by the manufacturer.

Place the base panel in the door opening. Hold the panel vertically by hammering the wall near the plank, then bend it to keep the panel in place. Make sure it is flat before attaching another panel.

Install the garage door

After following the steps above, you can now install your garage door panels, so let it begin.If you are installing a mirrored garage door, place a reinforcement bar on the top panel to prevent the door from sliding. inside the middle. Drill pilot holes and secure the pub with screws Twist hinges on the top of each panel Many new doors arrive with pilot holes drilled by the manufacturer The twist axle supports the base of the bottom panel and also at the top of the highest panel Set base panel to door opening Hold panel vertical by driving a nail into the wall near the plank, then bending it to hold the panel in place. 'it is flat before attaching another panel.